News

The faults of the display are divided into soft faults and hard faults. When our display fails to display properly, we should first analyze briefly, where the fault is, whether it is a software setup problem or if the internal circuit of the monitor is broken, and then determine if it is necessary. Send repairs […]

First, no display on power: It is more common for the inverter to display no fault on power-up, and basically it can be determined that the fault points are divided into: rectifier module, control card, and power supply card (driver card). Troubleshooting: 1. When the inverter is powered on without display, check the rectifier module […]

Because the displacement sensor can be made according to different principles and different methods, and the different sensors have different “perceived” methods for objects, so common proximity switches have the following types: 1. Eddy current proximity switch This type of switch is sometimes called an inductive proximity switch. It is the use of conductive objects […]

First, the installation direction and spacing The back side of MR-JE-40B~MR-JE-100B is equipped with a regenerative resistor. The temperature of the regenerative resistor may rise by 100 °C relative to the ambient temperature. Please take into account the heat dissipation, installation location and use of wires when configuring. 1, the installation interval of the servo […]

When choosing the right model of the camera, complex parameter comparisons such as image resolution, camera sensitivity and temperature range are often required. In short, the temperature range indicates the lowest temperature and highest temperature that a thermal imager can measure. What you should know about the wide temperature range of thermal imaging cameras 1. […]

The programmed program needs to be commissioned to confirm that the machine control requirements are met. In general, the debugging of sequential programs goes through two steps of “simulation debugging” and “online debugging”.     (1) Simulation debugging     “Simulation debugging”, also known as “simulation debugging”, refers to the use of special “simulation equipment” […]