1. Connect the PC / PPI cable (RS232C / RS485) PPI connector to the S7-200 PLC and connect the PC connector to the RS232 port of the F900GOT.
2. Set the F900 GOT target station number (DST station number) to the PLC address of the S7-200 series PLC.
3. In the “View / System Block” of the STEP 7-Micro / WIN 32 software, make the following settings:

 

4. Set the DIP switch on the PC / PPI cable as follows:
Switch 1 2 3 4 5
0 0 1 0 0

Leave a Reply

Your email address will not be published. Required fields are marked *