Mitsubishi PLC programming instructions

The transfer speed of the program corresponds to the PLC programming tool
FX3U / FX3UC programmable controller and GX Develope (Ver.8.13P above) between the use of the following interface, you can high-speed (115.2kbps) to execute the program write / read, monitor and so on.
The FX-30P can communicate with the FX3U / FX3UC programmable controller at high speed (115.2kbps).
1) Built-in programming port and RS-422 RS-422 converter with model FX-232AWC-H, or FX-USB-AW USB / RS-422 converter
When connected
2) Function extension board for RS-232C with FX3U-232-BD
3) Special adapter for RS-232C with FX3U-232ADP (-MB)
4) Model FX3U-USB-BD USB function expansion board
When the following interface is used between the FX3G programmable controller and GX Developer (Ver.8.72A or higher), the program can be written / read, monitored, and the like at high speed (115.2 kbps).
PLC programming
The FX-30P can communicate with the FX3G programmable controller at high speed (115.2kbps).
1) Built-in programming port (RS-422) and RS-422 with FX3G -422-BD function expansion board or RS-232C / RS-422 converter with model FX-232AWC-H
2) Function extension board for RS-232C with FX3G-232-BD
3) Special adapter for RS-232C with FX3U-232ADP (-MB)
In the corresponding programming software, use 9,600bps or 19,200bps for communication.
In addition, the setting of the communication speed of GX Developer is set in the following positions.
Double-click the [Serial] icon under [On line] → [Transfer setup] → [PC side I / F]